How does a frozen pipe turn into a flood?
Water expands as it freezes, and the pressure can split a pipe while the ice is still in place. When the ice thaws and the water runs again, the leak starts, often inside a wall or crawl space where no one is looking.
A pipe that freezes can crack without showing any sign until the thaw. The water runs into the wall cavity or floor and spreads along the framing before it reaches a visible surface. By the time a stain shows, the water may have traveled a long way from the break.
Pipes in an exterior wall, a crawl space or an attic are the most exposed. A hard freeze reaches them first, and the water that escapes can run down through the house. That is why a burst is often found in a room other than the one where it started.
How do you stop the water and make the house safe?
The first step is to shut off the water at the main or the nearest valve, then cut power to any wet area. Stopping the flow keeps the damage from growing while the cleanup is planned.
A homeowner who knows where the main shutoff is can close it at once. If the shutoff is hard to find or the water is near electrical fixtures, the homeowner leaves the wet area and calls for help. Electrical hazards come before the plumbing.
Once the flow is stopped, the crew confirms the building is safe to enter. Standing water near outlets or the panel is not entered until the power is confirmed off. The crew then works out the water path from the burst point.
What does drying a burst pipe involve?
Drying starts after the water is pumped and the wet materials are removed. Framing, subfloors and insulation along the water path are measured, dried and rechecked before the walls are closed.
Clean-water damage soaks into drywall, insulation and flooring, and each material holds water differently. The crew removes soaked carpet, pad and lower drywall to the readings, and opens the wall where the pipe was found to check the framing.
Air movers and dehumidifiers run until the framing reads dry, and each visit repeats the readings. Because the water came from a supply line, the crew watches for early staining and checks the cavity for moisture that has spread beyond the first room.
Can a frozen pipe cause mold?
Yes, if the water stays in the framing, insulation or flooring long enough for mold to start. Mold growth depends on moisture, time and material, so drying the structure completely is the main defense.
Mold can begin on wet drywall, wood and insulation within a few days when moisture stays in place. A burst pipe that is shut off and then left alone is a common route to that problem, because the water keeps working its way into the materials.
The crew checks for signs of mold during the cleanup and records what it finds. If mold is present, the homeowner should ask the company for its credentials and the scope of any remediation, because that work needs a separate plan.
How can a homeowner keep the pipes from splitting again?
Prevention depends on the pipe, the room and the weather. Insulating exposed lines and letting faucets drip during a hard freeze are the steps the National Weather Service advises.
Insulating pipes in unheated spaces is the most direct step. Foam sleeves and wrapped lines reduce the heat loss that lets water freeze, and they are simple to add in a crawl space or attic. A homeowner can check these lines before the first hard freeze of the season.
Dripping faucets keep water moving through the line, which lowers the pressure that splits a pipe. The water that runs is small compared with the cleanup a burst requires. (833) 490-5225 connects callers with the cleanup crew at any hour.