Hard freezes across the Upstate split supply lines, and a burst pipe can run unseen until someone notices the water. Shut the main supply, open a tap to drain the line, keep clear of wet outlets and call (833) 490-5225 for help with the water already inside the house.
Key takeaways
- Shut off the main supply first, then open a tap to drain the line so the flow stops and the pressure drops.
- Keep clear of wet outlets, the electrical panel and any appliance standing in water.
- Insulate exposed lines and let faucets drip during hard freezes, as the National Weather Service advises.
- A pipe that froze without splitting can still be weakened, so a wet wall or slow flow needs checking after the thaw.
- Photograph the damage and the broken section before any repair begins.
- Ask the crew to read the wall cavity and the floor below a burst, since water runs downward before it shows.
Why hard freezes split supply lines
Water expands as it freezes, and a supply line in a cold wall, crawl space or exterior cabinet can split under that pressure. The split may not show until the water thaws and starts to flow.
Lines that run through exterior walls, unheated crawl spaces, garages and attics are the most exposed, especially when a hard freeze arrives with little warning. A pipe with no insulation and no heat nearby is at the greatest risk, and a faucet on an outside wall can freeze back into the house before anyone notices a change.
Pipes burst across the Upstate in the freeze around Christmas 2022, and many owners learned about the problem only after the thaw. A split line can drip slowly inside a wall for a long time, so the first sign may be a stain, a soft ceiling or a sudden rise in the water bill. Look for those signs after any cold snap, even if the house seemed fine during the cold.
A plumber repairs the pipe, but the water already inside the house is the first concern. Knowing where the line runs and where it is most likely to have split helps both the plumber and the crew that dries the structure, and it lets each of them plan the work in the right order.
The first steps before anyone arrives
Stop the water at its source, drain what you can and keep yourself away from electricity. Those three steps matter more than anything else you can do before help arrives.
Find the main shutoff and turn it off. In many houses it sits at the meter near the street, on an outside wall or in a utility closet. Open the nearest tap at the lowest point of the house to drain pressure from the line. If you cannot find the main, call for help and describe where the water is showing.
Keep clear of water near outlets, the electrical panel, the water heater and the furnace. If water reaches the panel or outlets, do not touch them. If the panel itself is in water, leave it alone and call the power company or an electrician. Keep children and pets out of the wet room until the power there is confirmed off.
Once the water is stopped, begin a simple record: where the pipe is, which room is wet, when you noticed it and what you did. Those notes help the intake and the crew, and they form part of the record for any insurer.
Before a freeze, disconnect garden hoses from outside faucets and close the indoor valve that feeds each outside hose bib, if the house has one. A hose left attached can hold water in the line and freeze it, and a frozen outdoor line can split back into the wall. Drain the outside line after use, and note which valve controls it so the next owner or the next crew knows where to turn.
Insulate and drip to prevent the next freeze
The National Weather Service advises insulating exposed lines and letting faucets drip during hard freezes. Both are simple measures, and both lower the chance that the water in a line freezes solid.
Insulation wraps the pipe in a material that slows the loss of heat. Foam sleeves are a common choice for exposed lines, and they go on most easily before a cold spell arrives. Give extra attention to lines in exterior walls, under sinks against outside walls and in any unheated space the house shares with the pipes.
Dripping faucets keep a small amount of water moving through the line. Moving water is less likely to freeze than still water, which is why a thin drip at the faucet farthest from the main is often recommended during a hard freeze. Open the cabinet doors under sinks on outside walls so warm room air can reach the pipes.
Plan these measures before a hard freeze is forecast. In a storm, an owner is busy with the house and the forecast, and a short list kept near the main shutoff makes the job faster and safer when the cold actually comes.
Burst pipes and the water that spreads
A burst line releases water into the structure, not only onto the floor. The water runs along framing, down through cavities and into lower rooms, which is why the wet area is often larger than the visible damage.
Water from a split line can run down a wall cavity to the floor below, soak the insulation and reach a ceiling or a room downstairs. A small stain in one place may hide a wet path the length of the house. The crew should read the cavity and the floor below the break, not only the room where the water was first found.
Standing water on a floor is handled first, through pumping and extraction. Then the crew checks what the water touched: carpet and pad, baseboards, drywall and insulation. Drywall that wicked water may be cut back to a line set by readings, while cabinets and subfloors are checked for swelling and softness.
Ask for each removal to be described before it happens and recorded afterward. A burst that goes unnoticed for a while can leave materials wet longer than an owner expects, so the readings matter more than the look of the room.
Checking the pipe and the structure after a thaw
A pipe that froze without splitting can still be weakened, and a slow leak can run inside a wall for some time. Check the lines after a thaw and read the structure before anything is closed up.
After a thaw, run each tap and look for slow flow, sputtering or a change in pressure. Check the visible lines for cracks, bulges and wet spots. Look under sinks, behind the water heater and along any exposed line in a crawl space or garage, because those places are easy to miss in a hurry.
A wet wall or a soft patch of floor is a sign to stop and call. Do not cover the area with a new finish until a crew has read it with a meter. The readings show whether the water has gone, and they show where to open the wall if it has not.
Photograph each repair before the wall is closed. That photograph is the simplest record of where the pipe ran and where it was fixed, and it helps the plumber and any crew that works on the house later.
Ask the plumber to confirm that any repaired section is insulated or otherwise protected before the next cold spell. A repair that is left exposed in an unheated space can freeze again, and a short note of what was done and where makes that check easy the next winter.
Calling Spartanburg Water Damage Restoration about a frozen or burst pipe
Describe the line, the room and the state of the water on the phone. The intake will take the details and pass them to a crew that can read the wet area when it arrives.
When you call (833) 490-5225, someone picks up and takes the details. Mention whether the water is still running, whether you shut the main, where the line runs if you know it and whether the power to the room is confirmed off. Those facts decide the first safety steps and what the crew brings with it.
Phones are answered at any hour, so a call in the middle of a freeze reaches someone. The intake will not give a figure from the phone, and it will tell you what to keep clear and what to photograph while you wait.
Plumbing repair is a separate job from drying. Tell the intake if you already have a plumber, so the water and the repair can be planned in the right order. The drying crew and the plumber each need the same set of photographs to do their work.
Frequently asked questions
Should I run the heat if a pipe has burst?
Keep the house warm enough to protect the other lines, but do not use the electrical system in a wet area. If the power to the room is unclear, leave it off until it is confirmed.
Will the pipe thaw by itself?
It may thaw, but a split line keeps leaking once it does. Shut the main first and let the plumber decide the repair. Waiting for the thaw can add water to the structure while you wait.
Can I use a heater or a hair dryer on a frozen pipe?
Avoid open flames, and do not leave a heater running near wet materials or a pipe. Use gentle warmth and keep electrical devices well away from water. If in doubt, leave the thawing to the plumber.
Do I need to open the wall to dry it?
Often, when readings show moisture held inside the cavity. The crew should explain the opening, photograph it and close it only when the readings are back to target.
Why does a burst pipe sometimes lead to mold?
Wet materials that are not dried can later support mold growth. A fast shutoff and a proper drying plan with readings lower that risk considerably, and the record shows whether the plan was followed.
What if the cold returns after the repair?
Check the repaired section and the lines near it before the cold arrives. Insulate what is exposed, let the faucets drip if the forecast calls for hard freezing, and keep the main location written down. A repair made in cold weather is worth checking after the first hard night.
This guide is general information for Spartanburg County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.