How does water reach a low space?
Water enters a basement or crawl space through the walls, the floor, the openings and any drain or sump. Creek and storm water can rise against the outside wall and push through the weakest point.
Water rarely comes through one clean hole. It seeps through the foundation wall, rises through the slab or the dirt, and enters at the vents and access openings. A crawl space can take water from the uphill side and from the ground beneath it.
Sump pits and floor drains can be overwhelmed when the water table rises. When power goes out during a storm, a sump pump stops, and the water it was holding returns to the space.
What does silt do to the joists and insulation?
Silt settles on joists and insulation and dries into a crust. The crust holds moisture against the wood and feeds microbes, so it has to be cleared before drying starts.
A fine film of silt coats the underside of the subfloor and the top edge of the joists. Insulation that sat in the water holds the silt in its fibers and cannot be cleaned, so it is removed in sections and bagged.
Joists and piers are scraped and brushed to clear the silt, then washed with a cleaner suited to wood. The crew checks the end grain of the joists, where water tends to soak deepest.
How is the space pumped and dried?
Standing water is pumped out through the access points, then the space is dried with air movers and dehumidifiers. Drying runs until the joists and the subfloor reach their dry targets.
Pumps and wet vacuums remove the standing water from the lowest point. The crew sets up equipment through the vents or temporary openings and runs air across the joists and under the subfloor.
Moisture readings are taken at the joists near the ground, at the subfloor above and at the piers. The crew returns until every point reads dry, and the record notes each reading against its position.
What happens to the floor above?
The floor above is checked for swelling, staining, soft spots and a loose or cupped surface. Sections that stay wet are opened, and sound flooring can often be kept.
A floor above a wet crawl space can cup, lift or sag at the joist bays. The crew checks the subfloor from below and from above, and lifts a test section where the readings are unclear.
Basement floors with a finished surface are checked for moisture under the covering. Carpet that has been soaked is removed, and a concrete slab is dried before any new floor is laid. The record shows which surfaces were dry at the end.